Latest products and information available at www.sealite.com.au
15
Trouble Shooting
Problem Remedy
Lantern will not activate.
• Ensure internal toggle switch is set to the 'ON position.
• Ensure lantern is in darkness.
• Wait at least 60 seconds for the program to initialise in darkness.
• Ensure switch setting is on a valid code (See p8 – 14 of manual).
• Ensure battery terminals are properly connected.
• Ensure battery voltage is above 3.4volts.
Timing codes will not change.
• Turn rotary switches several times to ensure contacts are clear.
Lantern will not operate for
the entire night.
• Expose lantern to direct sunlight and monitor operation for
several days. Sealite products typically require 1.5 hours of direct
sunlight per day to retain full autonomy. From a discharged state,
the lantern may require several days of operational conditions to
'cycle' up to full autonomy.
• Reducing the light output intensity or duty cycle (flash code) will
reduce current draw on the battery.
• Ensure solar module is clean and not covered by shading during
the day.
Lanterns are constantly on
during the day.
• Ensure the flash code is not set to F F. This flash code is for
testing purposes only and will be steady on for 24 hours a day.
Lanterns are not
synchronizing together.
(Affects SL70-CS)
• The lanterns will take up to 3minutes to synchronize with the
surrounding lanterns.
• If you have a large number of lanterns, they may start ‘syncing’ in
groups. It may up to take 20 minutes for all lights to achieve full
synchronization. This is dependent on the distance between the
entire set of lanterns, the closer the lanterns, the quicker full
synchronization will occur.
• Ensure every light is set to the same flash code. Lanterns will
only synchronize to lanterns using the same flash code.
• Ensure the line of sight between 2 lanterns is clear on any
obstruction. Trees, buildings, other structures or vessels will
affect the lanterns ability to synchronize.
• Ensure the lanterns are no more than 1.5km apart over water.
All SL70-CS lanterns are fitted with a red Status LED. This is found near the Flash Code Switches.
It helps determine a fault with the unit depending on the flash rate of the Status LED.
Flash Rate
On (sec.) OFF
Mode Status Condition
Steady Off Off Normal Normal running condition in daylight.
1/10 1 On Normal Lantern is not synchronised to other lanterns.
1 1 On Normal Lantern is synchronised to surrounding lanterns.
Steady On Off Flat Battery Battery is flat.
1/10 1/10 On Low Battery Battery is low.
1 2/10 On Factory Set. Unit is in factory setup mode (FF). Change flash code.
(16 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern